|
Post by bertie930 on Oct 31, 2018 15:42:30 GMT
Hi All.
Could someone let me know the wheel nut spacings for a '73 Corolla Coupe?
I would like to put a nice set of alloys on the car but have read that they may be hard to find. Is this true?
Has anyone put Minilites on a Toyota?
Any ideas for types of wheels and where to buy would be appreciated.
Really want to get this beauty rolling.
Thank you.
Robert.
|
|
|
Post by harvey on Oct 31, 2018 19:25:53 GMT
4x110mm is the PCD , over 30 years ago I had a set of ford wheels on my KE20 they are 4x108mm and used the swivel seat "wobble" nuts and the didnt fall off ! Probably not the best idea however you can change the hubs and halfshafts to Starlet ones and they are 4x114.3mm which gives a lot more options. Club member Alan Cannell did such a conversion to his KE25 so would be the man to advise
|
|
|
Post by conquest on Nov 1, 2018 11:21:59 GMT
you could also get some PCD adapters I would put on some JDM wheels on that - www.kyushagarage.com.au/jdm-wheelshave a look at that site for some options some do come up on ebay so probably set up some searches on there...
|
|
|
Post by corollate27fan on Nov 16, 2018 13:35:03 GMT
4x110mm is the PCD , over 30 years ago I had a set of ford wheels on my KE20 they are 4x108mm and used the swivel seat "wobble" nuts and the didnt fall off ! Probably not the best idea however you can change the hubs and halfshafts to Starlet ones and they are 4x114.3mm which gives a lot more options. Club member Alan Cannell did such a conversion to his KE25 so would be the man to advise Can someone expand a little more on the front hubs and half shaft swap for a KE20, Alan if you are around perhaps you could PM me.. I have some KP60/61 front hubs and KE30 rear halfshafts and drums which I bought to put on my KE20. I was not sure if the front KP60/61 hubs were a straightforward swap but sounds like they might be. I understand that the rear halfshafts (and drums) can be made to fit by reducing the splined ends by about 5mm. Thanks all
|
|