Parts for TA22/23

[dabeca]

Hello everyone just dropping a note about a bloke selling a load of TA22/23 parts in Lincoln.

Dont know fully what he has but seems to lots of trim parts and crome things etc. I have just bought a rear axle off him.

If anyone is interested call Kevin on either 01522 575852 or mobile [phone] Good Luck and i hope he has the parts you need.

[tintin]

Hi new member TinTin here. I am hopeless on forums, i never know how to start one off. I have a ta22? Or at least i think itis 1976 on a P plate. Had it 4 years finally got stuck in and now ready for paint. Will post pics as soon as. Slight problem. Car has no front suspension on as i stripped it to fit new shox and brakes etc. Problem is my local parts supplier Partco(unipart) have supplied inserts. But originals were sealed units i.e. complete leg. I stripped it down by removing the large hex nut and although the insert fits in, its too long and the nut isn't long enough to hold it down. Checked with suppliers and its only 1 listed. Demon tweeks say they list for september 75 on but not pre september 75. Anyone come across this or can help? Suggestions appreciated.

[harvey]

Sounds like as you say its a TA23 insert they have supplied you with which is longer than the earlier TA22 unit.
I can measure a spare Koni insert for a 22 and give you a size.
Should manage that over the weekend

[irishta22]

I was talking to Kevin in Lincoln about a centre console for my TA22, he is getting me a price and postage costs for the weekend, hes a very decent and helpful fella, hea recommended for a try!

[tintin]

Thanks 4 quick response. when you say measure a ta22 insert, if its smaller any idea where i can get a pair? cheers

[alfazer]

Mmm sounds familiar, almost. The monroe inserts I used in my RA28 were a liitle too short! I packed them out with some penny washers to fit, but your problem a little trickier.
AL